4.9 (572) · € 16.00 · En Stock
I have this DHT22 sensor: It is a white case on a red board which has DAT, VCC and GND connections. Also to the left side it is labeled as AM2302 DHT22 sensor and on the right side it says 1400C80 In the sketch I am using, it says to Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor Is it necessary and if so will it give data readings, as presently it just gives 00% humidity and 0.0C temperature. Thanks
DHT22 Not measuring properly (Solved) - Sensors - Arduino Forum
DHT22 Shows wrong values how do I address this? - #16 by michinyon - Sensors - Arduino Forum
How to use DHT22 AM3302 Temperature and Humidity sensor with Arduino
DHT22 not working - Sensors - Arduino Forum
troubleshoot DHT22 Humidity sensor - Sensors - Arduino Forum
BMP280 Not Sending data - FAQ - Forum Sensor.Community
SOLVED] DHT11/DHT22 - Failed to read from DHT sensor
How to Use DHT-22 Sensor - Arduino Tutorial : 5 Steps - Instructables
No dht22 readings on esp8266 - Sensors - Arduino Forum
DHT Humidity Sensing - Raspberry Pi with Google Docs logging - Raspberry Pi Forums
Gammon Forum : Electronics : Microprocessors : Temperature and humidity sensor - battery powered
Sensor DHT22 and ESP8266-01 - Sensors - Arduino Forum
Resolved] Open a DHT22 Sensor - Sensors - Arduino Forum